John Deere 520
  • + Expand All
  • - Close All
  • Heavy-duty John Deere-designed gearbox
    Gearbox Gearbox

    A heavy-duty, John Deere-designed and John Deere-built gearbox transfers power to the Kevlar® drive belts through cross shafts with intermediate bearing supports:

    • The transmission is bolted directly to the frame.
    • This gearbox has a constant-duty rating of 180 hp and a maximum rating of 270 hp.
    • It carries a limited two-year warranty.

    Kevlar is a U.S.-registered trademark of E.I. du Pont de Nemours and Company.

  • Serviceability
    Lateral-bearing service access Lateral-bearing service access
    Center-bearing service access Center-bearing service access

    Hard-to-reach center bearings can be serviced with the conveniently located grease fittings at the rear of the machine:

    • There is no need for the operator to crawl under the machine to perform this service task, thus increasing the probability of the job being performed and completed safely.
  • Flail fastening system eliminates clogging from mud or crop residue
    Flail fastening system Flail fastening system
    #

    The flail fastening system eliminates clogging from mud or crop residue. Its bracket design also helps prevent knife and ring loss.

  • Steel rotor bearings for increased bearing life
    Rotor bearings Rotor bearings

    The rotor bearings are now made of steel and have a three-lip seal to keep the dirt out and increase the life of the bearings.

     

    The side and center bearings now have guards in order to avoid leaks and dust, increasing the life of the bearings.

  • Rubber deflectors will not dent or rust
    Rubber deflectors Rubber deflectors
    #
    Front rubber deflectors keep debris and other materials under the shredder and away from the tractor and operator. Because they are made out of rubber, they will not dent or rust.
  • Optional wheel supports eliminate uncut middle strip in non-row-crop field
    Wheel supports Wheel supports
    #

    Optional wheel supports eliminate the uncut middle strip in crops like wheat, oats, and barley. The shredder can be pulled at an angle, offsetting the rotors and cutting evenly across the entire width of the machine.

  • Drawn or integral model available to meet a variety of applications
    Hitch Hitch
    Drawn Drawn
    The 520 Flail Shredder can be ordered with two different types of tractor hookup, drawn or integral, depending on preference. An integral flail shredder allows making a very tight turning radius, even when the tractor is equipped with dual wheels.
  • Square rotor designed for superior rotor strength
    Rotor Rotor
    #

    Designed for superior rotor strength, the square rotor, together with the opposite-mounted flails, provides a machine with less potential vibration, increasing the life of rotor bearings and belts.

     

    Since 248 knives are mounted on the full length of the rotors on the main cutterbar, with 2.5 cm (1 in.) of overlap, a stalk won't get missed. This is a significant improvement over the 216 knives mounted on the previous 220 Flail Shredder.

Cutting capacity

Cutting height 7.6-25.4 cm
3-10 in.
Cutting width 6.1 m
20 ft